Applications:
2008-Up Sportsters with 25mm Bearings
2004-2005 Dyna With 1" Bearings
This is a conversion axle that will allow you to use a wheel with 3/4" Bearings(Timken or Sealed) with the 39mm Front Ends Listed Above
These are not imported junk, we make these axles, and they are machined from stainless steel bar stock, with ground bearing diameters and heat treated
These axles fit perfectly and will not chip, rust, or seize into your bearings.
Axle Spacers
Bikes
Bushings
Carb Spacers \ Adapters
Chain Conversion Kits
Coil Brackets & Coils
Compensator Eliminators
Compression Releases
Controls, Mid, Forward & Spacers
Electric Start and Kick Starter Parts
Engines
EVO Engine Parts
Fat Tire Kits
Fender Struts & Spacers
Fenders
Fork Cups & Raked Fork Cups
Frame Parts
Front Ends & Parts
FXR & Dyna Parts
Gaskets \ Seals
Handlebar Risers, Grips & Levers
Hardware
Headlights
Ignitions & Coils
Inner Primary Rings
Motor Sprockets & Shaft Extensions
Panhead \ Shovelhead Engine Parts
Pulley Spacers \ Adapters
Sportster
Swing Arms & Parts
Tools, Harley Specialty
Top Motor Mounts
Transmission - Other
Transmission Base Plates
Transmission Sprockets & Pulleys
Triple Trees
Twin Cam Engine Parts
Twin Cam Motor Adapter Plates
Wheel Conversion Kits
Wheels
Xzotic Cam Covers
Xzotic Knucklehead Rocker Boxes
Xzotic Panhead Rocker Boxes
